International normalized ratio (INR); prothrombin time
Values obtained with different assay methods should not be used interchangeably in serial testing. It is recommended that only one assay method be used consistently to monitor each patient's course of therapy. This procedure does not provide serial monitoring; it is intended for one-time use only. If serial monitoring is required, please order the serial monitoring test, 485199.
If the patient's hematocrit exceeds 55%, the volume of citrate in the collection tube must be adjusted. Refer Coagulation Collection Procedures for directions.
Within 1 day
Turnaround time is defined as the usual number of days from the date of pickup of a specimen for testing to when the result is released to the ordering provider. In some cases, additional time should be allowed for additional confirmatory or additional reflex tests. Testing schedules may vary.
For more information, please view the literature below.
Whole blood or plasma
2.7 mL-sized tube filled to 90% capacity or 1.8 mL-sized tube filled to 90% capacity.
90% of full draw (Note: This volume does not allow for repeat testing.)
Blue-top (sodium citrate) tube; do not open tube unless plasma is to be frozen.
Blood should be collected in a blue-top tube containing 3.2% buffered sodium citrate.1 Evacuated collection tubes must be filled to completion to ensure a proper blood-to-anticoagulant ratio.2,3 The sample should be mixed immediately by gentle inversion at least six times to ensure adequate mixing of the anticoagulant with the blood. A discard tube is not required prior to collection of coagulation samples unless the sample is collected using a winged (butterfly) collection system. With a winged blood collection set a discard tube should be drawn first to account for the dead space of the tubing and prevent under-filling of the evacuated tube.4,5 When noncitrate tubes are collected for other tests, collect sterile and nonadditive (red-top) tubes prior to citrate (blue-top) tubes. Any tube containing an alternative anticoagulant should be collected after the blue-top tube. Gel-barrier tubes and serum tubes with clot initiators should also be collected after the citrate tubes.
Please print and use the Volume Guide for Coagulation Testing to ensure proper draw volume.
Specimens are stable at room temperature for 24 hours. If testing cannot be completed within 24 hours, specimens should be centrifuged for at least 10 minutes at 1500xg; plasma should then be transferred to a Labcorp PP transpak frozen purple tube with screw cap (Labcorp No. 49482). Freeze immediately and maintain frozen until tested. Refer to Coagulation Collection Procedures for directions.
Clotted specimen; hemolysis; tube <90% full; improper labeling; specimen collected in tube other than 3.2% citrate; refrigerated specimen
Evaluation of the extrinsic coagulation system; aid in screening for congenital and acquired deficiencies of factors II, V, VII, X, and fibrinogen.6-8 This test is used clinically for the therapeutic monitoring of warfarin (Coumadin®) anticoagulant therapy.
The PT test may not be sensitive to slight deficiencies of single factors.9 Heparin can extend the PT.9 Lupus anticoagulants may affect prothrombin time producing results that do not accurately reflect the true level of anticoagulation. The PT (and aPTT) results can be extended in patients receiving antithrombin anticoagulants such as hirudin and argatroban.9 These patients can be monitored for warfarin effectiveness with a chromogenic factor X assay, which is not affected by lupus anticoagulant or thrombin inhibitors.9
Prothrombin time reagent containing thromboplastin and calcium chloride is mixed with the patient plasma and the time to clot formation is measured photo-optically. The calcium chloride overcomes the citrate anticoagulant and allows the tissue factor in the thromboplastin to initiate coagulation. The prolongation of the clotting time correlates with the degree of deficiency or inhibition of the extrinsic pathway factors.
Prothrombin Time (PT)
0 to 30 d
1 to 6 m
7 m to 1 y
2 to 17 y
International Normalized Ratio (INR)
0 to 1 m
The thromboplastin reagent used by LabCorp consists of recombinant tissue factor mixed with synthetic phospholipid. Recombinant tissue factor is free from contamination with coagulation factors that can be found in tissue factor extracted from other sources. This serves to increase the PT assay's sensitivity for factor efficiencies. Prothrombin time results are reported in seconds and are also converted to international normalized ratio (INR) values. The INR serves to normalize results obtained from different laboratories for the variable responsiveness of different thromboplastin reagents. Each thromboplastin is assigned an activity Index (ISI) based on comparison to an international reference thromboplastin from the World Health Organization. The formula for calculating the INR is
INR = [patient's results / normal patient average](ISI)
The ISI of the thromboplastin used in the LabCorp assay is near 1.0. The use of low ISI thromboplastin serves to improve the precision of therapeutic monitoring by enhancing sensitivity of the prothrombin assay.
The PT is sensitive to deficiencies of extrinsic and common pathway factors X, VII, V, II, and fibrinogen.6-8 The PT is more responsive to deficiencies of factors X and V than is the aPTT. Congenital deficiencies of these factors are relatively rare and cause bleeding disorders of varying severity. Refer to individual test descriptions for more information. Acquired deficiencies of the vitamin K-dependent factors II and VII may occur during warfarin therapy and in patients with vitamin K deficiency. Diminished levels of all the factors of the extrinsic pathway can also occur in consumptive coagulopathies, such as disseminated intravascular coagulation (DIC), and as the result of decreased factor production as can be seen with severe liver disease or malnutrition. Specific inhibitors of extrinsic pathway factors are extremely rare, but may produce a prolonged PT.6-8 Lupus anticoagulants (LA) may cause a prolonged PT due to nonspecific factor inhibition. Some individuals with LA can develop antibodies that bind to and increase the rate of clearance of prothrombin (factor II). These patients typically have an extended PT due to reduced factor II level and an increased risk of bleeding.
Coumarins, a family of compounds that inhibit the vitamin K-dependent carboxylation of several coagulation factors, are commonly used to limit fibrin clot formation in individuals with increased risk of venous or arterial thrombosis.10-12 Warfarin, also referred to as Coumadin®, is the most commonly used coumarin in North America.11 Overdosing with warfarin can increase the risk of hemorrhage and inadequate dosing decreases the efficacy of anticoagulation. Unfortunately, a large number of factors can affect the pharmacological potency of these oral anticoagulants. These factors are reviewed in considerable detail in the American Heart Association/American College of Cardiology Foundation Guide to Warfarin Therapy.12 Therapeutic monitoring is essential to maintain the dosage within the appropriate range range. Because the PT is sensitive to deficiencies of vitamin K-dependent factors II and VII, it is used to monitor warfarin therapy.
Coumarins inhibit the carboxylation of procoagulant factors II, VII, IX, X, and anticoagulants proteins C and S to a similar extent. Steady-state levels of these proteins are all reduced to a similar degree, based on the dose and effectiveness of the oral anticoagulant given; however, during the initial days of treatment, the rate of decline of factor levels is dependent on their half-life. Since factor VII has a short half-life relative to other vitamin K-dependent factors, the levels of this factor drop much more precipitously than the others.11
Superwarfarins, such as brodifacoum, are often found in rat poison and may cause prolongation of the PT. Patients suffering brodifacoum poisoning respond to vitamin K often bringing their PT into the normal range briefly, but since the drug is stored for long periods of time in fat, the PT rises again over time.
|Order Code||Order Code Name||Order Loinc||Result Code||Result Code Name||UofM||Result LOINC|
|005199||Prothrombin Time (PT)||34528-0||115107||INR||6301-6|
|005199||Prothrombin Time (PT)||34528-0||015289||Prothrombin Time||sec||5902-2|
|Reflex Table for INR|
|Order Code||Order Name||Result Code||Result Name||UofM||Result LOINC|
|Reflex 1||115109||INR (Thromborel-S)||115109||INR (Thromborel-S)||6301-6|
|Reflex Table for Prothrombin Time|
|Order Code||Order Name||Result Code||Result Name||UofM||Result LOINC|
|Reflex 1||015290||PT (Thromborel-S)||015290||PT (Thromborel-S)||sec||5902-2|
© 2023 Laboratory Corporation of America® Holdings and Lexi-Comp Inc. All Rights Reserved.
The LOINC® codes are copyright © 1994-2023, Regenstrief Institute, Inc. and the Logical Observation Identifiers Names and Codes (LOINC) Committee. Permission is granted in perpetuity, without payment of license fees or royalties, to use, copy, or distribute the LOINC® codes for any commercial or non-commercial purpose, subject to the terms under the license agreement found at https://loinc.org/license/. Additional information regarding LOINC® codes can be found at LOINC.org, including the LOINC Manual, which can be downloaded at LOINC.org/downloads/files/LOINCManual.pdf