5 - 7 days
Turnaround time is defined as the usual number of days from the date of pickup of a specimen for testing to when the result is released to the ordering provider. In some cases, additional time should be allowed for additional confirmatory or additional reflex tests. Testing schedules may vary.
For more information, please view the literature below.
Two plastic transport tubes (containing at least 3.5 mL each) of frozen plasma
One plastic transport tube (containing at least 3.5 mL) of frozen plasma. Note: This volume does not allow for repeat testing.
4-mL BD® purple-top (K2 EDTA) tube. Collect six tubes of whole blood in accordance with the collection procedure specified below.
Please label each final plasma collection tube with the word "Plasma". Testing will be delayed if the tube is not labeled properly.
• Blood should be collected according to your laboratory's procedure for venipuncture using only a 4-mL BD® purple-top (K2 EDTA) tube. Plasma preparation should be performed within four hours after blood is collected. Store, transport, and ship plasma at frozen condition only. The plasma sample can be stored frozen at -15°C to -25°C for 14 days.
• Do not freeze whole blood samples.
Plasma Specimen Preparation
• Immediately following specimen collection, label all tubes with appropriate patient information (two patient identifiers, minimum).
• The brake setting of the Drucker 642e at LabCorp is 3 or 4 (manufacturer setting).
• Centrifuge the six BD purple-top (K2 EDTA) tubes for 10 minutes at 1600±90 rcf. (For conversion of RPM [revolutions per minute] to rcf [relative centrifugal force], refer to the centrifuge manufacturer's user manual.)
• Remove blood collection tubes from the centrifuge. (Plasma sample will be rejected if it is hemolyzed. Patient will be contacted.)
• Using a fresh, six-inch disposable transfer pipette, transfer plasma from three 4-mL tubes to one 8.5-mL Sarstedt centrifuge tube (55.598.006).
• Repeat this process with the second set of three 4-mL tubes. Two 8.5-mL tubes will be collected from six 4-mL tubes.
• Centrifuge plasma in the 8.5-mL centrifuge tube for 10 minutes at 1600±90 rcf.
• Using a fresh, six-inch disposable transfer pipette or serological pipette, transfer 3.5 mL of plasma from one 8.5-mL centrifuge tube into a labeled 7-mL Sarstedt screw-cap, flat-bottom purple frozen transport tube (62.550.019).
• Repeat this process with the second 8.5-mL centrifuge tube.
• Two 7-mL tubes will be collected.
• Ship and store plasma at -15°C to -25°C. Stable for 14 days.
• Take care not to disturb or transfer the buffy coat (white blood cells) layered above the red blood cells in the blood collection tube after the first centrifugation or sedimented at the bottom of the centrifuge tube after the second centrifugation.
Freeze. The plasma sample could be stored frozen at -15°C to -25°C for 14 days.
Hemolyzed specimen; plasma not frozen; volume <3.5 mL per tube; leaking or broken tubes
Epi proColon® is a qualitative in vitro diagnostic method for the detection of methylated Septin 9 DNA in EDTA plasma derived from patient whole blood specimens. Methylation of the target DNA sequence in the promoter region of the SEPT9_v2 transcript has been associated with the occurrence of colorectal cancer (CRC).
The Epi proColon® test is indicated to screen adults of either sex, 50 years or older, defined as average risk for CRC, who have been offered and have a history of not completing CRC screening. Tests that are available and recommended in the USPSTF 2008 CRC screening guidelines should be offered and declined prior to offering the Epi proColon® test. Patients with a positive Epi proColon® test result should be referred for diagnostic colonoscopy.
The Epi proColon® test results should be used in combination with physician's assessment and individual risk factors in guiding patient management.
The clinical performance of Epi proColon® was reported with a sensitivity range of 68.2%, 73.3%, and 72.2% and a specificity range of 78.8%, 81.5%, and 80.8% in the package insert for Trial One and in Trial Two (all plasma specimens, and paired Fecal Immunochemical Test specimens) respectively when compared to colonoscopy. (See package insert, Table 12, 14a, and 14b, p27-28).
DNA is isolated from plasma specimen and treated with bisulfite. Real-time polymerase chain reaction (PCR) is performed on ABI 7500 Fast Dx to detect methylated form of Septin 9 DNA.
|Order Code||Order Code Name||Order Loinc||Result Code||Result Code Name||UofM||Result LOINC|
|481160||Epi proColon(R), Septin 9, IVD||481161||Septin 9 Result:||65810-4|
|481160||Epi proColon(R), Septin 9, IVD||481166||Indications:||42349-1|
|481160||Epi proColon(R), Septin 9, IVD||481167||Specimen Type:||31208-2|
|481160||Epi proColon(R), Septin 9, IVD||481162||Background:||77202-0|
|481160||Epi proColon(R), Septin 9, IVD||481163||Methodology:||49549-9|
|481160||Epi proColon(R), Septin 9, IVD||481164||References:||75608-0|
|481160||Epi proColon(R), Septin 9, IVD||481165||Director Review:||72486-4|
© 2021 Laboratory Corporation of America® Holdings and Lexi-Comp Inc. All Rights Reserved.
The LOINC® codes are copyright © 1994-2021, Regenstrief Institute, Inc. and the Logical Observation Identifiers Names and Codes (LOINC) Committee. Permission is granted in perpetuity, without payment of license fees or royalties, to use, copy, or distribute the LOINC® codes for any commercial or non-commercial purpose, subject to the terms under the license agreement found at https://loinc.org/license/. Additional information regarding LOINC® codes can be found at LOINC.org, including the LOINC Manual, which can be downloaded at LOINC.org/downloads/files/LOINCManual.pdf